RAD Data comm 10/100BaseT to STM-1/OC-3 Converter RIC-155 - Manual (Page 42)

Chapter 4 Configuration RIC-155 Installation and Operation Manual
4-6 Configuring the RIC-155 for Operation
RIC-155
TELNET Access (Enable)
1. Enable
2. Disable
3. Managers only
Please select item <1 to 3>
ESC-prev.menu; !-main menu; &-exit
Figure 4-7. TELNET Access Menu
To enable or disable management ports:
1. From the Management Access menu, select Physical Ports Access.
The Physical Ports Access menu appears (see Figure 4-8 ).
2. From the Physical Ports Access menu, select None to disable both inband and
out-of-band management, MNG only to enable out-of-band management only
(via MNG port), or All to enable management via Ethernet management and
data ports.
Appendix B illustrates connections between the management port, data port,
STM-1/OC-3c port and the CPU within internal bridge.
Whenever the Physical Ports Access mode is changed, the POS Port Egress
(STM-1/OC-3c) and Tag Stripping (data and management Ethernet ports) are set to
their default values as explained in
Appendix B .
RIC-155
Physical Ports Access (All)
1. None
2. MNG only
3. All
Please select item <1 to 3>
ESC-prev.menu; !-main menu; &-exit
Figure 4-8. Physical Ports Access Menu
4.2 Configuring the RIC-155 for Operation
The RIC-155 management software allows you to perform the following:
• Setting source clock
• Defining control port parameters
• Defining alarm severity and masking alarms
• Resetting RIC-155 to the default values
• Performing the overall reset of the device.
Note