Device name, Contact person, System location – RAD Data comm E1 Interface Converter RIC-E1 User Manual
Page 74: Interface parameters menu, Figure d-13
Appendix D IR-IP Interface Module
RIC-E1 Installation and Operation Manual
D-18
Advanced Setup Menu
IR_IP
S/W Ver. 1.21 31/IR (date)
Quick Setup
Management Access
Advanced Setup
.....................................................................
Device
identification
=====================================================================
1. Device Name
:IR-IP..
2. Contact Person
:Name of contact Person
3. System Location
:The location of this device
Press one of the numbers to select or ESC:
Figure D-13. Device Identification Menu
Device Name
Select this parameter to assign an arbitrary name to IR-IP for identification by the
system manager (up to eight characters). The assigned name is displayed in the
screen header.
Contact Person
Select this parameter to enter the name of the person to be contacted with matters
pertaining to this equipment unit.
System Location
Select this parameter to enter the physical location of the device.
Interface Parameters Menu
The Interface Parameters menu is used to control the operation of IR-IP interfaces.
To access the Interface Parameters menu:
• From the Advanced Setup menu, type 2.
The Interface Parameters menu appears (
IR_IP
S/W Ver. 1.21 31/IR (date)
Quick Setup
Management Access
Advanced Setup
.................................................................
Device
identification
Interface
Parameters
=================================================================
1. LAN Status
:[ Open ]
2. WAN Status
:[ Open ]
3. WAN Throttle
:[ Full ]
4. Aging Timeout (min) :5.
Press one of the numbers to select or ESC:
Figure D-14. Interface Parameters Menu
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com