RAD Data comm E1 Interface Converter RIC-E1 - Manual (Page 16)

Chapter 1 Introduction RIC-E1 Installation and Operation Manual
1-2 Physical Description
Application
RIC-E1 is typically used to connect between a G.703 network and a DTE. The DTE
can be a multiplexer, a bridge, a router etc.
Figure 1-1 illustrates a typical RIC-E1
application.
DTE
V.35
RIC-E1
G.703
Network
Figure 1-1. Typical Application
1.2 Physical Description
A three-dimensional view of RIC-E1 and RIC-T1 is shown in Figure 1-2 .
Figure 1-2. RIC-E1 and RIC-T1, 3D View
The RIC-E1 front panel contains LEDs that show the status of the unit. For more
information, refer to
Chapter 3 .
The RIC-E1 rear panel contains the DTE interface, the G.703 link and the power
connections. For more information, refer to
Chapter 2 .
A description of how to set the internal jumpers can be found in Chapter 2 .
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com