RAD Data comm E1 Interface Converter RIC-E1 - Manual (Page 59)

RIC-E1 Installation and Operation Manual Appendix D IR-IP Interface Module
Technical Specifications D-3
xDSL. Users on the LAN who register with the IR-IP for an IP multicast group using
the IGsMP protocol filter IP multicast packets at wire-speed.
Management and advanced configuration of the IR-IP module are performed via
Telnet.
Application
Figure D-1 shows a typical application of the RIC-E1 interface converter equipped
with the IR-IP module.
RIC-E1
10BaseT LAN
G.703
Network
Figure D-1. Typical Application of RIC-E1 with IR-IP Module
D.2 Technical Specifications
Router LAN IP net Up to 256 hosts on LAN IP net
Filtering and
Forwarding 30 kbps / 35 kbps
Buffer 256 frames (maximum size – 1534 bytes)
Delay 1 frame
LAN Standard IEEE 802.3/Ethernet V2
Data Rate 10 Mbps (20 Mbps 10BaseT in full duplex topology)
Connector 10BaseT: Shielded RJ-45
WAN Protocols • PPP (PAP/CHAP)
• Frame Relay (RFC 1490)
• HDLC
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com