Ir-ip m, Anagement, Ubsystem – RAD Data comm E1 Interface Converter RIC-E1 User Manual
Page 62: Eneral, Table d-3, Lists, D.4 ir-ip management subsystem, general
Appendix D IR-IP Interface Module
RIC-E1 Installation and Operation Manual
D-6
IR-IP Management Subsystem, General
Table D-3. IR-IP Controls
Control
RIC-E1 RIC-E1/R
Function Values
Default
Setting
DIP switch,
section 1
IP LEARN
pushbutton,
DIP switch,
section 5
Enables IR-IP to learn its IP
ON
– IP address learning is enabled
OFF
– IP address learning is disabled
OFF
Note: IP LEARN pushbutton settings override settings of the DIP switch.
DIP switch,
section 2
DIP switch,
section 4
Selects the WAN protocol
ON
– PPP protocol
OFF
– Frame Relay protocol
OFF
DIP switch,
section 3
DIP switch,
section 3
Selects the LAN mode
ON
– Full duplex operation
OFF
– Half duplex operation
OFF
DIP switch,
section 4
DIP switch,
section 2
Controls the remote WAN test
loopback, which returns
packets received from the
WAN back toward the WAN
ON
– The test loopback is activated
OFF
– The test loopback is disabled
OFF
– DIP
switch,
section 6
Allows the user to operate the
module in case the IP address
and/or Telnet password are lost
ON
– Forces default IP password
and/or no password protection
OFF
– IR-IP operates according to
user configuration
OFF
– DIP
switch,
section 1
Not in use
– –
When using the IP LEARN pushbutton for the IP address configuration, make sure
that the PNL SW jumper (JP5) on the RIC-E1/R PCB is set to EN.
provides the pinout of the IR-IP RJ-45 connector.
Table D-4. RJ-45 Pinout
Pin Name
Function
1
TD (+)
Transmit data positive
2
TD (-)
Transmit data negative
3
RD (+)
Receive data positive
6
RD (-)
Receive data negative
D.4 IR-IP Management Subsystem, General
The IR-IP interface module management subsystem supports the following
functions:
• Preliminary configuration
• Configuration of management access parameters
• Advanced configuration of IR-IP parameters
• Collection and display of statistical performance data
• Maintenance functions, which include:
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com