RAD Data comm E1 Interface Converter RIC-E1 - Manual (Page 48)

Appendix B IR-ETH Interface Module RIC-E1 Installation and Operation Manual
B-4 Installation and Operation
B.3 Technical Specifications
General LAN Table 10,000 addresses
Filtering and Forwarding 15,000 frames per second
Buffer 256 frames
Delay 1 frame
LAN Standard Conforms to IEEE 802.3/Ethernet
Data Rate 10 Mbps (20 Mbps 10BaseT FDX)
Connectors • 10BaseT (UTP): Shielded RJ-45
• 10Base2: BNC connector
WAN Protocol (internal) HDLC
Data Rate E1 (2048 kbps)
B.4 Installation and Operation
Figure B-4 shows the rear panel of the IR-ETH module with 10BaseT connector.
Figure B-5 shows the ERR D4 LED and the DIP switch, which are located on the
reverse side of the IR-ETH module installed in the standalone unit.
The DIP switch and the LED are located on the top panel of the IR-ETH module
installed in the RIC-E1/R card.
Figure B-4. IR-ETH Rear Panel (10BaseT Connector)
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com