RAD Data comm E1 Interface Converter RIC-E1 User Manual
Page 51
Introduction C-1
Appendix C
IR-ETH/V Interface Module
Contents
.......................................................................................... C-1
.................................................................................... C-2
Standalone RIC-E1............................................................................... C-2
.......................................................................... C-4
.................................................................... C-4
Setting the DIP Switches ...................................................................... C-5
Connecting the LAN ............................................................................ C-6
C.1 Introduction
The IR-ETH/V interface module replaces the IR-ETH/QN interface module.
The IR-ETH/V has improved functionality, however, it should be noted that there
are now two priority queues available. IR-ETH/V includes a high performance
self-learning Fast Ethernet bridge, which is connected to the LAN via a single
10BaseT or 100BaseT port, operating in full or half duplex and providing simple
and cost-effective interconnection between 10/100BaseT LANs. The IR-ETH/V
interface module also supports IEEE 802.1p frames and IEEE 802.1q frames,
enabling VLAN applications.
The module automatically learns MAC addresses of the LAN to which it is
connected. Its LAN table stores up to 2,048 addresses with 5-minute automatic
aging. Filtering and forwarding is performed at wire speed.
shows a typical application using RIC-E1 with IR-ETH/V module.
RIC-E1
10/100BaseT LAN
G.703
Network
Figure C-1. Typical Application of RIC-E1 with IR-ETH/V Module
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com