RAD Data comm E1 Interface Converter RIC-E1 - Manual (Page 25)

RIC-E1 Installation and Operation Manual Chapter 2 Installation and Setup
Configuring RIC-E1 2-5
Connecting the DTE
RIC-E1 supports various types of data channel interfaces. Equipment with V.35,
X.21, RS-530 and Ethernet interfaces can be connected directly to the RIC-E1 DTE
port. The RIC-E1 V.36 interface is provided via an adapter cable converting
between 25-pin RS-530 connector and 37-pin V.36 connector.
Connector pin allocations and cable wiring data appear in
Appendix A . For the
detailed description of the IR-ETH, IR-ETH/ V, and IR-IP Ethernet interface
modules, refer to Appendix B , Appendix C , and Appendix D, respectively.
Connecting the Power
Refer to the appropriate section below depending on the RIC-E1 version – AC or
DC.
Connecting the AC Power
AC power should be supplied to the RIC-E1 unit through the 1.5m (5 ft) standard
power cable terminated with a standard 3-prong plug. The cable is provided with
the unit.
Before connecting power to the unit, verify that the socket outlet is provided
with a protective ground contact. If you are using an extension cord (power
cable) make sure it is grounded as well
Interrupting the protective (grounding) conductor (inside or outside the unit),
or disconnecting the protective ground terminal can make this unit dangerous.
Make sure that only fuses of the required rating (0.250A, 250V) are used for
replacement. Do not use repaired fuses or short-circuit the fuse holder. Always
disconnect the mains cable before removing or replacing the fuse. If there is a
chance that the fuse protection has been damaged, make the unit inoperative.
To connect AC power to RIC-E1:
1. Connect the power cable to the power connector on the RIC-E1 rear panel.
2. Plug the RIC-E1 power cable to the mains outlet.
RIC-E1 turns on automatically upon connection to the mains.
Connecting the DC Power
To connect DC power:
• Refer to the DC power supply connection supplement.
Warning
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com