beautypg.com

Chapter 1. introduction, Overview, Versions – RAD Data comm E1 Interface Converter RIC-E1 User Manual

Page 15: Dte interface, Power supply, Chapter 1 introduction

background image

Overview 1-1

Chapter 1
Introduction

1.1 Overview

RIC-E1 is an interface converter. It converts unframed HDB3 or AMI data of ITU
G.703 E1 balanced or unbalanced interface into an interchangeable DTE interface
module.
RIC-E1 operates at 2048 kbps. It extracts data and the clock from the G.703
interface via a jitter attenuator to meet ITU G.823 requirements.
RIC-E1 acts as a line transceiver. It provides protection from over-voltage and

over-current stress caused by lightning, power crosses and other noise sources.

Versions

The following versions of the RIC-E1 converter are available:
• RIC-E1 standalone unit
• RIC-E1/R – a plug-in card for installation in the ASM-MN-214, 19-inch

modem/converter rack, holding up 14 cards (see

Chapter 5

for the RIC-E1/R

description).

DTE Interface

RIC-E1 can be ordered with one of the following DTE interfaces:
• V.35
• X.21
• V.36
• RS-530
• Ethernet:

IR-ETH (Ethernet bridge)

IR-ETH/V (Ethernet/Fast Ethernet bridge with VLAN support,
replaces IR-ETH/QN)

IR-IP (IP router).

Power Supply

• AC power supply: 100 to 240 VAC
• DC power supply: 24 or -48 VDC.

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610

www.bestdatasource.com