beautypg.com

Technical specifications, 4 technical specifications – RAD Data comm E1 Interface Converter RIC-E1 User Manual

Page 18

background image

Chapter 1 Introduction

RIC-E1 Installation and Operation Manual

1-4 Technical

Specifications

1.4 Technical Specifications

Link Interface

Coding

HDB3 or AMI

Framing

Unframed

Bit Rate

2.048 Mbps

Impedance

120Ω, balanced
75Ω, unbalanced

RCV Signal Level

0 to -10 dB

XMT Signal Level

3V (±10%), balanced
2.37V (±10%), unbalanced

Connectors

RJ-45, 8-pin, balanced
Two BNC coaxial, unbalanced

Return Loss

Better than 15 dB

DTE Interface

Type

• V.35: 34-pin, female
• X.21: 15-pin, D-type female
• V.36: 37-pin, D-type female, via adapter

cable

• RS-530: 25-pin, D-type female
• IR-ETH: RJ-45 or BNC
• IR-ETH/V: RJ-45
• IR-IP: RJ-45

Control Signals

V.35, X.21, RS-530:
• CTS follows RTS
• DCD follows E1 state

V.35, RS-530:
• DSR is constantly ON

Timing

Derived from three alternative sources:
• Internal oscillator
• External, from the attached DTE
• Receive, derived from the received signal

Indicators

PWR (green)

On – RIC-E1 is powered

TXD (yellow)

On – Data is being transmitted to the link

RXD (yellow)

On – Data is being received from the link

LOS (red)

On – No E1 data is received from the link

TST (red)

On – The local loopback is active

For description of the IR-ETH, IR-ETH/V and IR-IP interface modules, refer to

Appendix B

,

Appendix C

, and

Appendix D

, respectively.

Note

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610

www.bestdatasource.com