Roland SPD-S - Manual (Page 96)

96
Effect List
3: STEREODELAY (Stereo Delay)
Adds a delay in stereo to the original sound to produce a fat sound or special effects.
When FbkMode is NORMAL When FbkMode is CROSS
In addition, if you press the PAGE buttons, “Knob,” “Velo” and “Pedal” are displayed. You can then select the parameters to be
controlled with the EFFECTS CONTROL knob, the strength (velocity) used in hitting a playing surface, and the expression pedal.
Parameter Value Descriptions
EQ Low -12.0–+12.0 dB Low frequency amplification/attenuation
EQ High -12.0–+12.0 dB High frequency amplification/attenuation
DelayL 1.5–2000 ms Delay time from the start of the original sound to the start of the delay sound both
on L and R channels
DelayR
Feedback
-98–+98% Rate at which the delay sound is fed back (Negative: reversed phase)
FbkMode NORMAL, CROSS Destination into which the delay sound is fed back (See the diagram)
PhaseL NORMAL, INVERSE Phase of the delay sound on L/R channel
NORMAL: non-inversed phase
INVERSE: inversed phase PhaseR
LF Damp THRU, 50–4000 Hz Cutoff frequency for low frequency damping (THRU: no damping)
HF Damp 200 Hz–12.5 kHz, THRU Cutoff frequency for high frequency damping (THRU: no damping)
DelayLevel 0–127 Volume level of the delay sound
Value Parameters controlled with Knob, Velo and Pedal
(See the table above for details.) Descriptions
OFF — —
DELAYTIME DelayL, DelayR The delay time is controlled on both L and R channels
at the same time.
* When you control them, noise may be produced.
FEEDBACK Feedback —
DELAYLEVEL DelayLevel —
L out
Feedback
L in
DelayLevel
Delay
2-Band
EQ
R out
Feedback
R in
DelayLevel
Delay
2-Band
EQ
L out
Feedback
L in
DelayLevel
Delay
2-Band
EQ
R out
Feedback
R in
DelayLevel
Delay
2-Band
EQ
SPDS_e.book 96 ページ ２００４年４月１９日 月曜日 午前９時５８分