Roland SPD-S - Manual (Page 88)

88
Chapter 7 Changing the Setup (Overall Environment)
Wave Protect
This feature provides protection to sampled waves to prevent them from being lost by mistake.
The wave protect setting is remembered when the SPD-S is powered off. When you next power the SPD-S on, the SPD-S is booted
with the latest wave protect setting active.
Its factory setting is ON (enabled).
Enabling the wave protect
1. When the wave protect is OFF (disabled), hold down [WAVE] and [SETUP], and power the SPD-S on.
After the indication "Welcome to SPD-S," "wave protect on" appears and the wave protect is set to ON
Disabling wave protect
1. When wave protect is ON (enabled), hold down [WAVE] and [SETUP], and power the SPD-S on.
After the indication "Welcome to SPD-S," "wave protect off" appears and wave protect is set to OFF.
When wave protect is ON, the following operations cannot be executed with a "wave protected!" message indicated.
• WAVE TRUNCATE and WAVE DELETE in Wave Edit
• BACKUP LOAD in Card Utilities
• DELETE ALL WAVES and DELETE ALL in Setup Edit
SPDS_e.book 88 ページ ２００４年４月１９日 月曜日 午前９時５８分