Roland SPD-S - Manual (Page 90)

90
Shortcut List
Patch Mode
Patch Edit
Patch Utilities
Wave Mode
Wave Edit
Wave Utilities
Operation Function
[SHIFT]+[EXIT] Cancel the effects control.
[FUNC] Press it for a moment to lock or unlock buttons.
[EFFECTS]+[EDIT] Jump to the effect-type selection screen in Patch Edit.
[PATCH]+[-], [PATCH]+[+] Adjust the contrast of the display.
Operation Function Applicable screens
[SHIFT]+[FUNC] Load the initial value. —
[SHIFT]+[EXIT] Cancel the effects control. Patch Mode, Patch Edit
[SHIFT]+[ENTER] Copy the settings for the currently selected playing
surface to all other playing surfaces. WAVE A, WAVE B, PAD CONTROL
[SHIFT]+[<], [SHIFT]+[>] Change or select the playing surface. —
Hit the playing surface
while holding [SHIFT] Switch ON/OFF Effects SW in PAD CONTROL. EFFECTS
Switch ON/OFF Tempo Sync in PAD CONTROL. PATCH COMMON/Sync Tempo
[FUNC] Switch between WAVE A screen and WAVE B screen. WAVE A, WAVE B
Switch the function of the EFFECTS CONTROL knob
between the controller and the value dial. EFFECTS (excluding Type, Knob, Velo
and Pedal)
While held down, the pad indicators of pads for
which EFFECTS SW is set to VELO light. PAD CONTROL/Effects SW
[FUNC]+[-], [FUNC]+[+] Change the sync tempo. PAD CONTROL/Tempo Sync
Operation Function Applicable screens
[SHIFT]+[<], [SHIFT]+[>] Change or select the playing surface. —
[FUNC]+[-], [FUNC]+[+] Confirm or select the patch. PAD COPY, PAD EXCHANGE
Operation Function
[SHIFT]+[WAVE] Add a mark. Press it for a moment to remove a mark.
[SHIFT]+[ALL SOUND OFF] Jump to the wave delete screen in wave utilities.
[SHIFT]+[FUNC] Select a new (empty) wave number.
[FUNC] While held down, the wave tempo and length are indicated.
Operation Function Applicable screens
[SHIFT]+[WAVE] Add a mark. Press it for a moment to remove a mark. Start and End in START/END POINT
[SHIFT]+[FUNC] Load the initial value. —
[SHIFT]+[<], [SHIFT]+[>] Move the cursor. Start and End in START/END POINT
[FUNC] Execute automatic calculation of the end point. End in START/END POINT
Operation Function Applicable screens
[SHIFT]+[FUNC] Select a new (empty) wave number. Dst
[FUNC] While held down, Remain is indicated. WAVE PITCH/Dst, WAVE CHOP/Piece,
WAVE CHOP/Dst, WAVE COPY
SPDS_e.book 90 ページ ２００４年４月１９日 月曜日 午前９時５８分