Roland SPD-S - Manual (Page 62)

62
Chapter 4 Resampling an existing wave
Parameters for Resampling
*1 : Initial value for resampling in the patch mode
*2 : Initial value for resampling in the wave mode
Parame-
ter Value Descriptions Patch (*1) Wave (*2)
Gain 50–400% Set the gain applied to the original wave. 100% 100%
Mode MONO,
STEREO Select MONO or STEREO for the wave.
A wave in stereo has two voices. MONO Same as
the origi-
nal wave
Grade LONG,
STANDARD,
FINE Specify the wave grade (quality).
LONG: Lower sound quality than STANDARD, but uses half the
memory space of STANDARD.
STANDARD: Great quality sound.
FINE: Highest sound quality but consumes double the memory
space used by STANDARD. Two voices are utilized in this
grade.
STAN-
DARD Same as
the origi-
nal wave
Type SINGLE,
PHRASE * This parameter is valid only when resampling in patch mode.
Set the wave type to SINGLE or PHRASE. (p. 45)
* The initial value is SINGLE when all original waves are in SIN-
GLE. The initial value is PHRASE if any one of the original
waves is in PHRASE.
See the
note in the
descrip-
tions. N/A
Auto End OFF, ON Select automatic termination according to the length of the original
wave, or manual termination by pressing [START/STOP]. ON ON
Dst
(Destina-
tion) I 001–399,
C 001–500
* This parameter is valid only when resampling in wave mode.
Specify the wave number to which a created wave is to be saved.
I 001–399: To the internal memory
C 001–500: To the memory card
* By pressing [CARD], you can select the top number of the inter-
nal memory or of the memory card.
* If you press [SHIFT] and [FUNC], a new (empty) wave number
is selected.
N/A The top of
the new
(empty)
wave
numbers
Other Descriptions
Remain Displays the duration for which new resampling is possible (the remaining time). The duration varies depending on
the Mode and the Grade. This value is for indication only.
* The duration is indicated in terms of minutes (m) and seconds (s) while [FUNC] is depressed in parameter set-
ting.
If you hold down [SHIFT] and press [FUNC], the parameter is reset to its initial value.
SPDS_e.book 62 ページ ２００４年４月１９日 月曜日 午前９時５８分