Roland SPD-S - Manual (Page 86)

86
Chapter 7 Changing the Setup (Overall Environment)
Retrieving Saved Data Back to the SPD-S
Retrieves the settings saved to sequencers and other external MIDI devices to the SPD-S.
The data stored on the SPD-S is overwritten. Save necessary data to external MIDI devices before executing this operation.
Set the device ID (Device ID in MIDI in Setup Edit -> p. 84) used for saving bulk data.
1. Connect the MIDI IN connector on the SPD-S to the MIDI OUT connector of an external sequencer using
a MIDI cable.
2. Press [PATCH] to enter patch mode.
Bulk data cannot be retrieved in any mode other than patch mode.
3. Transfer the settings data from the external sequencer to the SPD-S.
The transferred settings are restored.
MIDI OUT MIDI IN
SPD-S
External Seqencer
SPDS_e.book 86 ページ ２００４年４月１９日 月曜日 午前９時５８分