Roland SPD-S - Manual (Page 66)

66
Chapter 5 Layering Performances to Make a Phrase (Phrase Maker)
Parameters for Phrase Resampling
Parameter Value Descriptions
Gain 50%–400% Specify the gain applied to the original wave.
Mode MONO,
STEREO Select MONO or STEREO for the wave. If you select stereo, the wave has two voices.
Grade LONG,
STANDARD,
FINE Specify the grade of the wave.
LONG: produces a poorer sound quality than that of STANDARD, but consumes half the
memory space that STANDARD uses.
STANDARD: produces standard sound quality.
FINE: produces the highest sound quality but consumes double the memory space used by
STANDARD. Two voices are used in this grade.
Dst
(Destina-
tion) I 001–399,
C 001–500
Specify the wave number to which a created wave is to be saved.
I 001–399: To the internal memory
C 001–500: To the memory card
* By pressing [CARD], you can select the top number of the internal memory or of the mem-
ory card.
* If you press [SHIFT] and [FUNC], a new (empty) wave number is selected
Other Descriptions
Remain Displays the duration for which new sampling is possible (the remaining time). The duration varies depending on
the Mode and the Grade. This value is for indication only.
* The duration is indicated in units of minutes (m) and seconds (s) while [FUNC] is depressed in the parameter
setting.
If you hold down [SHIFT] and press [FUNC], the parameter is reset to its initial value.
SPDS_e.book 66 ページ ２００４年４月１９日 月曜日 午前９時５８分