Renesas Emulation Probe M306V8T-EPB - Manual (Page 18)

M306V8T-EPB User’s Manual 1. Outline
REJ10J0777-0100 Rev.1.00 2005.08.01 Page 18 of 90
1.4 Specifications
Tables 1.5 lists the specifications of the M306V8T-EPB.
Table 1.5 Specifications of the M306V8T-EPB
Applicable MCU M16C/60 Series M16C/6V Group M306V8
Applicable MCU mode Single-chip mode
Memory expansion mode 16 bit bus width (Normal, Memory expansion mode 2)
Microprocessor mode 16 bit bus width (Normal, Memory expansion mode 2)
Maxi. ROM/RAM capacity 1. MCU internal flash ROM: 516KB (0F000h--0FFFFh, 80000h--FFFFFh)
2. MCU internal RAM:
16KB (00400h--043FFh)
3. MCU internal flash OSDRAM: 4KB (08000h--08FFFh)
4. MCU internal flash OSDROM: 128KB (30000h--4FFFFh)
Applicable power supply Vcc1 = Vcc2 = Vcc3: 3.15--3.45 V
Maximum operating frequency Power supply voltage 3.15 to 3.45 V: 16 MHz
Emulation memory 1. Access area: Flash ROM of MCU
Max.
operating frequency: 10 MHz
2. External area (CS3*--CS0* area) Possible to allocate up to 4 areas by 4 KB
- Maximum operating frequency (at 3.3 V) 0 wait: 6 MHz
1--3 wait: 16 MHz
Basic debugging functions - Download
- Address match break (max. 8 points)
- Software break (max. 64 points)
- Program execution/stop (allows free-run execution supporting software breaks)
- Memory reference/setting (reference/setting C-variables, run-time execution)
- Register reference/setting
- Disassemble display
- C-level debugging, etc.
Real-time trace function - 256K-cycle bus information recordable
(Bus, external trigger, time stamp)
- 5 trace modes supported (Break/Before/About/After/Full)
- Can be recorded ON/OFF by events
Real-time RAM monitor function - 4,096 bytes (256 bytes x16)
- Data/last access result
Hardware break function 8 points (Execution address, bus detection, interrupt, external trigger signal)
Execution time measurement function Time between program start and stop
Maximum/minimum/average execution time and pass count of specified four zones.
Count clock: Equal to MCU Clock or 16 MHz
C0 coverage 8,192 KB (256 KB x 32 blocks)
External trigger input/event output External trigger input (MCU-dependent-voltage CMOS level x8) or event output
(break x1, event x7)
Host machine interface - LPT parallel (ECP, EEP, Byte/compatibility and Nibble/compatibility modes)
- USB (USB 1.1, full-speed)*
- LAN (10BASE-T)
Power supply to emulator Supplied from included AC adapter (power supply voltage: 100--240 V, 50/60 Hz)
Connecting the User System
(see 2.9 "Connecting the User
System" on page 30) M306V8T-PTC (pre-mounted) converter board for 116-pin 0.65-mm-pitch LQFP
(116P6A-A)
* Available to connect the host machine that supports USB 2.0.
With the USB interface, not all hardware (such as host machine, USB devices, USB hub) combination will work and
guaranteed.