Nortel Networks Passport Module 8672A - Manual (Page 82)

82 Chapter 5 Managing the Passport 8672ATM Module with the CLI
209195-A
Figure 27 Sample output for the config atm info command
Show commands
This section discusses the CLI show commands available with the Passport
8672ATM Module. These commands allow you to view information about the
module:
show ports info atm all [<ports>]
show ports info atm ports [<ports>]
show ports info atm pvc [<ports>]
show ports info atm 1483 [<ports>]
show ports stats atmport [<ports>]
show ports stats atm felinecurrent [<ports>]
show ports stats atm felineinterval <intervalid> [<ports>]
show ports stats atm fepathcurrent [<ports>]
show ports stats atm fepathinterval <intervalid> [<ports>]
show ports stats atm linecurrent [<ports>]
show ports stats atm lineinterval <intervalid> [<ports>]
show ports stats atm pathcurrent [<ports>]
show ports stats atm pathinterval <intervalid> [<ports>]
show ports stats atm sectioncurrent [<ports>]
show ports stats atm sectioninterval <intervalid> [<ports>]
show ports stats atm sonetmediumtbl [<ports>]
Refer to Reference for the Passport 8000 Series Command Line Interface
Switching Operations, and Reference for the Passport 8000 Series Command Line
Interface Routing Operations for a complete list of CLI show commands.
show ports info atm all command
This command displays information (Figure 28) about the configuration for the
specified port or for all ports. The command uses the syntax:
show ports info atm all [<ports>]
number-vpi-bits : 4
scrambling : Enable
framing-mode : SONET
clock-source : Free Running
loop-back-mode : off
state : up