Nortel Networks Passport Module 8672A User Manual
Page 135
Chapter 6 Configuring the Passport 8672ATM Module
135
Using the Passport 8672ATM Module
config vlan 2 create byport 1
config vlan 3 create byport 1
2
To add an ATM port (in this example, 1/1) and several Ethernet ports (in this
example, 3/40 to 3/48) to the VLAN, enter:
config vlan 2 port add 1/1
config vlan 3 port add 3/40-3/48
3
To configure IP addresses on both VLANs (use two different subnets), enter:
config vlan 2 ip <ip address>/<subnet mask>
config vlan 3 ip <ip address>/<subnet mask>
4
To enable routing on both VLANs, enter:
config vlan 2 ip rip enable
config vlan 3 ip rip enable
If necessary, use the following CLI commands to change RIP parameters:
config vlan 2 ip rip <sub-command>
config ip rip <sub-command>
5
To configure an ATM 1483 PVC with LLC/SNAP-encapsulation and UBR,
enter:
config atm 1/1 pvc create 0.100 enc 1483-llc serv
ubr
6
To associate the 1483 IP routed PVC with a VLAN, enter:
config atm 1/1 pvc 1483 ip create 2 0.100
side IP address>
The remote IP address should be in the same subnet with the ATM port IP
address.
Configuring an IPX routing 1483 PVC using Device Manager
, the Passport 8672ATM Module has an
ATM 1483 PVC as the sole member of a VLAN configured for IPX routing.