Nortel Networks Passport Module 8672A - Manual (Page 79)

Chapter 5 Managing the Passport 8672ATM Module with the CLI 79
Using the Passport 8672ATM Module
config atm pvc command
Table 17 describes the parameters and variables for the config atm pvc
command.
Table 17 config atm pvc command parameters and variables
info Shows the last saved port settings and the next-level CLI commands.
Note that this does not show the current settings, but the last saved
settings.
perform-tagging disable> Enables or disables tagging.
Parameters and variables Description
create < vpi.vci> [name ]
[enc ] [serv ] [pcr
] [scr ] [mbs
] Creates a PVC. The required parameters are:
• vpi is the circuit VPI. Enter a numeric value, within the range
0...255.
• vci is the circuit VCI. Enter a numeric value, within the range
0...65535.
Note: For , 0.0 is not supported.
The optional parameters are:
• name is the display string. Enter up to 256 alphanumeric
characters to name PVC.
• enc is the 1483 encapsulation method, either null or llc-snap.
• serv is the bit rate, either ubr or vbr.
• pcr, with VBR only, is the peak cell rate. Enter an integer from 86 to
733490.
• scr, with VBR only, is the sustained cell rate. Enter an integer from
86 to 733490.
• mbs, with VBR only, is the maximum burst size. Enter an integer
from 2 to 255.
Note that no VLANs or ELANs are bound to this PVC until you add
VLAN membership using the config atm pvc 1483 commands.
delete Deletes the specified PVC. Note that this command will fail if the PVC
is still being used by RFC 1483 traffic.
info [] Displays PVC information.
Table 16 config atm command parameters and variables (continued)
Parameters and variables Description