Nortel Networks Passport Module 8672A - Manual (Page 40)

40 Chapter 3 Installing the Passport 8672ATM Module
209195-A
For information on configuring and managing the Passport 8672ATM Module,
refer to
Chapter 4, “Managing the Passport 8672ATM Module with Device
Manager,” on page 47 , to Chapter 5, “Managing the Passport 8672ATM Module
with the CLI,” on page 73 , and to Chapter 6, “Configuring the Passport 8672ATM
Module,” on page 115 .
Verifying installation
The Passport 8672ATM Module front panel has an Online LED that indicates
whether or not the module has power applied and is initialized correctly. For
information on online LEDs, see
“Online LED” on page 28 .
Initialization
When the Passport 8672ATM Module is installed into a Passport 8600 series
chassis, ensure that the Passport 8690SF module in the same chassis has a
PCMCIA card inserted and that the PCMCIA card contains the p80t3100.dld
image, which supports the Passport 8672ATM Module. For more information
about the PCMCIA slot and the Passport 8690SF module, refer to Using the
Passport 8600 Modules.
The Passport 8690SF module retrieves the image file p80t3100.dld to download
to the Passport 8672ATM Module. First, the Passport 8690SF module searches the
host flash memory for the file, then the PCMCIA card. The Passport 8690SF
module downloads the image file to the Passport 8672ATM Module and identifies
which MDAs are installed. The screen displays following message:
Using image = /slot/p80t3100.dld for ATM card download.
ATM card: Slot 4 MDA [OC-12c MM] [Quad OC-3c MM] Ver=2.2
If the image file is not found in either the flash memory or the PCMCIA, the
system stops and the screen displays an error message such as:
Note: You cannot configure the Passport 8672ATM Module until the
online LED on the module is steadily lit green and you have inserted at
least one MDA.