Nortel Networks Passport Module 8672A - Manual (Page 128)

128 Chapter 6 Configuring the Passport 8672ATM Module
209195-A
Configuring an IP routing 1483 PVC using Device Manager
In the configuration shown in Figure 56 , the Passport 8672ATM Module has an
ATM 1483 PVC as the sole member of a VLAN configured for IP routing.
Figure 56 IP routing with ATM 1483 PVCs
This configuration requires the following procedures:
• “Creating a VLAN “byPort” and adding ports” on page 119
• “Assigning IP addresses” on page 129
• “Enabling RIP routing” on page 131
• “Configuring a null-encapsulation PVC” on page 134
• “Associating the PVC with the VLAN” on page 134
Note: Because the spanning tree protocol (STP) is not supported on the
Passport 8672ATM Module, ensure that you have no parallel paths to the
destination.
Note: Each configured ATM 1483 PVC uses one VLAN. The Passport
8672ATM Module can be configured for a maximum of 256 VLANs per
MDA and a maximum of 512 VLANs per card.
9938EB
RFC 1483 Routed PVC
ATM VC1
2.x
ATM VC1
2.x
Traditional
Router
ATM Switches
1.x 3.x
Passport