Nortel Networks Passport Module 8672A - Manual (Page 126)

126 Chapter 6 Configuring the Passport 8672ATM Module
209195-A
config atm 1/1 pvc create 0.100 enc 1483-null serv
vbrscr mbs
4 To associate the ATM 1483 bridged PVC with a VLAN, enter:
config atm 1/1 pvc 1483 elan create 2 0.100
Bridging point-to-multipoint traffic using an ATM 1483 PVC
using Device Manager
In the configuration shown in Figure 55 , the Passport 8672ATM Module is
configured as a bridging hub to spokes through the WAN. Bridging is not allowed
between PVCs in the same ELAN. For point-to-multipoint bridging, the end
stations connected by each PVC circuit cannot communicate with one another.
Figure 55 Point-to-multipoint bridging using ATM 1483 PVCs
This configuration requires the following procedures:
• “Configuring two ATM 1483 PVCs on the same ATM port ,” next
• “Associating the PVCs with the same VLAN” on page 127
Use Device Manager or the CLI to perform these configuration and related tasks
on the Passport 8672ATM Module.
9937EB
VLAN2
VLAN1
Passport
RFC 1483 Bridged PVCs
ATM VC1
ATM VC2
Online MDA 2 MDA 1 8672 ATM
VLAN2
VLAN1
Centillion
ATM VC1
ATM VC2
ATM VC3
AT
M VC3
ATM Switches
VLAN1
Centillion