Nortel Networks Passport Module 8672A - Manual (Page 141)

Chapter 6 Configuring the Passport 8672ATM Module 141
Using the Passport 8672ATM Module
Follow the instructions there except, in the ConnectType field, select Ipx instead
of bridged.
Configuring an IPX routing 1483 PVC using the CLI
To configure the Passport 8672ATM Module for this setup using the CLI:
1 To create two VLANs by port, enter:
config vlan 2 create byport 1
config vlan 3 create byport 1
2 To add an ATM port (in this example, 1/1) and several Ethernet ports (in this
example, 3/40 to 3/48) to the VLAN, enter:
config vlan 2 port add 1/1
config vlan 3 port add 3/40-3/48
3 To configure IPX network numbers on both VLANs (use two different
subnets), enter:
config vlan 2 ipx <ipx network number>
config vlan 3 ipx <ipx network number>
4 To enable forwarding on IPX, enter:
config ipx forwarding enable <ipx network number>
5 If necessary, use the following CLI commands to change RIP parameters:
config ipx rip <sub-command>
config ip forwarding <sub-command>
6 To configure a 1483 PVC with LLC/SNAP-encapsulation and UBR, enter:
config atm 1/1 pvc create 0.100 enc 1483-llc serv
ubr
7 To associate a 1483 IPX routed PVC with a VLAN, enter:
config atm 1/1 pvc 1483 ipx create 2 0.100 <IPX
network number of existing vlan>