Planet Technology IPX-2000 - Manual (Page 84)

6.9.3 ISDN Port Configuration Settings
Table 6-15 ISDN Port Configuration Settings
Field Description
Type The type of this port.
Port The ID number of physical port.
Impedance/CP Tone The Impedance/CP Tone setting determines the dial tone,
ct busy tone, and ringback tone to the originating party. Sele
the appropriate impedance/call-progress tone for the local
region.
Default Codec Select g711ulaw or g711alaw for connecting to other
devices.
Compand Type Compand standards vary between countries. Select
MULAW or ALAW for the local region.
Signaling Select Point to point or Point to multipoint depends on
the link type between ISDN service provider and your
device.
Caller ID Leave it blank to have the default caller ID, or enter a caller
ided by your ISDN service provider. ID that is prov
6.10 Digitmap Configur
The digitmap is for Centrex DID in SIP trunks. A pattern consists of digits 0-9 (including “-”), “*”, “#”,
card characters like “.”, “X”, “Z”, and “N”. in
ildcard characters.
rn is for some PSTN saver lines that may set “#” as their dial pattern. For
ress “#” will immediately send out the dialed number.
. Enter settings show in Table 6-16.
3. Click
ation
digit set, and wild Route Configuration explains digit set and
w
Note: The “#” in the patte
most of the IP Phones, p
6.10.1 Add a Digitmap
1. Click the Add New tab.
2
to see the pattern in the list.
4. Click Add to have newly added digitmap.
73