Planet Technology IPX-2000 - Manual (Page 111)

9.2.2.1 Connection
1. Connect the console port with a computer using RS232.
2. Open a terminal emulator such as HyperTerminal on the computer.
. Configure the serial port setting as follows:
9.2. ommands
This general users.
Help
Displ
CLI C
Disp mands after the commands you entered
CLI C
Qui
Enter
CLI C
Exit
Exit t
inter you are in admin level, enter this command will disable and back to basic level.
CLI C
3
• Baud Rate: 115200
• Data: 8 bit
• Parity: none
• Stop: 1 bit
• Flow Control: none
4. Click OK to connect.
9.2.2.2 Login
Type in the login username and password (both are estcli).
2.3 Basic C
section describes basic command lines for
ay the help message command available for the level.
ommand: help / ?
lay the available com
ommand: ?
t / Logout
the command to Logout CLI.
ommand: quit / logout
he current level and go back to the previous level. If you are in the basic level, the console
face will logout. If
ommand: exit
100