Planet Technology IPX-2000 - Manual (Page 61)

extensions and SIP trunks in the IPBX, as well as for
all IP phones registered to the IPBX. If it is not
feasible to set the same DTMF mode for some IP
extensions or SIP trunks, and inline transfer or
2nd-dialing is necessary for those IP extensions or
SIP trunks, the Fast Bridging feature can be disabled
on a per IP extension and per SIP trunk basis. Note
that Fast Bridging is enabled by default.
Try Peer-to-peer RTP If click YES, IP PBX will attempt to notify the two peers in a
conversation to try peer-to-peer RTP transmission. This is
suggested as long as phones support INVITE or UPDATE
method during a connected call to save the resource of IP
PBX. However, only SIP INFO DTMF mode phones should
enable this since other DTMF modes require IP PBX being
RTP relay server to support in-line transfer.
DTMF Mode Choose preferred DTMF mode for this extension. Currently
supported types include RFC2833, SIP INFO, and in-band
tone. It must match configuration on the device side.
)
In-band DTMF mode consumes the limited DSP
resource when using a highly compressed codec,
such as G.729 or G.723.1. Therefore, calls will not
connect with such setting if DSP is not installed.
Although using a low-complexity codec such as G.711
does not require DSP, DTMF detection still takes
considerable CPU resource and impacts several
system specs. Be cautious when configuring an
extension with in-band DTMF mode.
Advanced Settings Select to see more optional settings shown below.
Select Block Anonymous Calls to block all calls without a
Caller ID.
Selective Call Blocking
Block one or more calling numbers by entering the calling
numbers and clicking . Removing the blocked
numbers by clicking the number from the list, and then click
.
Block SIP redirection from the
extension
Select to ignore the forward settings of IP phone and honor
the forward settings of IP PBX.
50