Planet Technology IPX-2000 - Manual (Page 45)

5 Service Configuration
This section describes details to configure various services built in the IP PBX.
5.1 NTP Service
Select Service -> NTP Service to specify a NTP server for network time synchronization. You can
enable or disable NTP service at any time.
5.1.1 Enable NTP Service
1. Click Enable.
2. Select the Automatic check box to use server pool at pool.ntp.org; or, enter a fully qualified
domain name or the IP address of a NTP server.
3. Click Apply.
5.1.2 Disable NTP Service
Click Disable, and click Apply.
5.2 SNMP Service
Select Service -> SNMP Service to specify Simple Network Management Protocol (SNMP)
parameters for network status retrieval. You can enable or disable SNMP service at any time.
5.2.1 Enable SNMP Service
1. Click Enable.
2. Enter System Location, System Administrator Contact, SNMPv2 Read-only Community
with allowed network specifications, and also those of the SNMPv2 Read-write Community.
3. Click Apply.
5.2.2 Disable SNMP Service
Click Disable, and click Apply.
34