Promise Technology FAST TRAK100TM User Manual
Page 79
FastTrak100 User Manual
75
errors, but do not want to fix these errors at the time. You may then
decide what to do about the error(s) detected.
ECC Error Reported on Synchronize
The following screen will appear if a data error is detected on either source or target
drive during Synchronize if you have set the On Errors setting to “Interactive”
within FastCheck’s Options Window for Scheduled Synchronization (see page 60)
or for Manual Synchronization under Notification options (see page 59).
Your choices are as follows:
Abort: Halts the synchronization process. You may elect to retry at a later
date.
Fix the Error Block: FastTrak100 will take a good data block from either
drive and copy it to the drive where the error was detected.
Skip the Error Block: FastTrak100 will log the event error and continue the
synchronization process. Use this setting if you want to detect the
presence of errors, but do not want to fix these errors at the time. You
may then decide what to do about the error(s) detected.