Promise Technology FAST TRAK100TM - Manual (Page 65)

FastTrak100 User Manual
61
Ignore: FastTrak100 will log the event error and continue the
synchronization process. (Warning: this may result in mismatched
drives under RAID 1 or 0+1). Use this setting if you want to detect the
presence of errors, but do not want to fix these errors at the time. The
user may then decide what to do about the error(s) detected.
Interactive: By checking this option, a selection window will appear
each time an error is detected asking the user whether they want to
Abort, Fix, or Ignore the error (see Troubleshooting for more details).
Schedule event drop down box allows scheduling synchronization by minute,
by hour, by day, by week, or by month. If enabled, the default is By Month.
This allows synchronization to take place during an off-hour when the
system is either not in use or not at peak demand.
Start time designates hr/min/ am/pm
On the designates day of week or by ordinal (1st, 2nd, 3rd....) selection.
Setting Rebuild Options
Disable Hot Spare/Auto Rebuild checkbox turns off the use of a “hot” spare
drive and automatic rebuilding of a mirrored array. The default is unchecked
(or enable Hot Spare/Auto Rebuild).
Rebuild Rate assigns the amount of importance that FastTrak100 gives to
mirroring data from one drive to another in the background. A “high”
setting assigns most of FastTrak100’s resources to the rebuild process at
the expense of responding to ongoing read/write data requests by the
operating system. A “low” setting gives priority to ongoing read/write data
requests by the operating system at the expense of the rebuild process
and will typically result in longer rebuild times. The setting shown above is
the default.