Promise Technology FAST TRAK100TM - Manual (Page 32)

FastTrak100 User Manual
28
Deleting An Array
The Delete Array <4> Menu option allows for deletion of disk array assignments.
This is not the same as deleting data from the drives themselves. If you delete an
array by accident (and before it has been used again), the array can normally be
recovered by defining the array identically as the deleted array.
WARNING: Deleting an existing disk array could result in its data loss.
Make sure to record all array information including the array type, the
disk members, and stripe block size in case you wish to undo a
deletion.
FastBuild (tm) Utility 1.xx (c) 1995-2000 Promise Technology, Inc.
[ Delete Array Menu ]
Array No
RAID Mode Total Drv Capacity(MB) Status
Array 1 Stripe 2 16126 Functional
Array 2 Mirror 2 8063 Functional
Array 3 —— —— —— ——
Array 4 —— —— —— ——
[ Keys Available ]
[
↑
] Up [
↓
] Down [ESC] Exit [Del] Delete
1. To delete an array, highlight the Array you wish to delete and press the [Del]
key.
2. The View Array Definition menu will appear (see below) showing which drives
are assigned to this array.
FastBuild (tm) Utility 1.xx (c) 1995-2000 Promise Technology, Inc.
[ Define Array Menu ]
Array No RAID Mode
Total Drv Capacity(MB) Status
Array 1 Stripe 2 16126 Functional
Stripe Block: 64 KB
[ Drive Assignments ]
Channel:ID
Drive Model Capacity (MB) Assignment
1 : Master QUANTUMCR8.4A 8063 Y
2 : Master QUANTUMCR8.4A 8063 Y
3. Confirm yes to the following warning message with the key to
continue array deletion:
Are you sure you want to delete this array?