Promise Technology FAST TRAK100TM - Manual (Page 46)

FastTrak100 User Manual
42
Windows NT4.0
Installing Drivers During Windows NT 4.0 Installation
1. Start the system installation by booting from the Windows NT disk:
a) Floppy install: boot the system with the Windows NT installation diskettes.
b) Floppyless install: boot from floppy and type “WINNT /B”. After files have
been copied, the system will reboot. On the reboot, press the “F6” key
when the message “Setup is inspecting your computer’s hardware
configuration…” appears.
c) CD-ROM disk install: boot from the CD-ROM disk and press
the “F6” key when the message “Setup is inspecting your com-
puter’s hardware configuration…” appears.
2. When the “Windows NT Setup” window is generated, press “S” to Specify an
Additional Device(s).
3. Press “O” to select “Other” and press the “Enter” key.
4. Insert the Promise Technology

FastTrak100 driver diskette into drive A: and
press the “Enter” key.
5. Choose “WinNT Promise FastTrak100 (tm) Controller” from the list that
appears on screen, then press the “Enter” key.
6. The Windows NT Setup screen will appear again saying “Setup will load
support for the following mass storage devices:” The list will include
“WinNT Promise FastTrak100 (tm) controller”.
NOTE: If you need to specify any additional devices to be installed, do so at
this time. Once all devices are specified, continue to step 7.
7. From the Windows NT Setup screen, press the Enter key. Setup will now load
all device files and then continue the Windows NT installation.
2. After a successful installation, the “SCSI Adapter Setup” box will show that
the “WinNT Promise FastTrak100 (tm) Controller” driver has been installed.