Dos/windows 3.1x – Promise Technology FAST TRAK100TM User Manual

Page 45

FastTrak100 User Manual

Confirming Driver Installation in Windows 98/95

To confirm that the driver has been properly loaded in Win 95/98, perform the
following steps:

1. Choose “Settings” from the “Start” menu.

2. Choose “Control Panel,” and then double-click on the “System” icon.

3. Choose the “Device Manager” tab, and then click the “+” in front of “SCSI &

RAID controllers.” “Win95-98 Promise FastTrak100 (tm) controller” should
appear

DOS/Windows 3.1x

For first-time installation, follow the standard procedure of installing DOS on to your
hard disk (partition all hard drives with FDISK and format before performing the
following procedure):

1. Insert “Disk 1” of your DOS installation diskettes into drive A:.

2. Type “A:SETUP” at the “A:\” prompt.

3. Continue with normal DOS installation procedure, and refer to your DOS

manual for additional details.

NOTE: The FastTrak100 BIOS supports both DOS and Windows 3.1x without
software drivers.