Powerware Model V-2000B - Manual (Page 94)

92 = Hard Disk Management
Determining the Condition of The RAID Array
Figure 32: Report of RAID Array Condition
To replace a failed drive in the RAID control utility, perform the following steps.
• Select the [Remove Drive] option next to the DEGRADED drive.
• The DEGRADED message next to the drive will change to NOT PRESENT.
• If you suspect the drive is damaged, or if a previous Rebuild attempt has failed:
1. Power down the system.
2. Replace the failed drive with a drive of identical storage space. Detailed information
about how to replace hard drives is on page 110.
3. Restart the system.
4. Repeat the steps described earlier in this chapter – up to this point – then continue…
• Click on the Rescan Controller button to identify available drives. The following window
will appear: