beautypg.com

Replacing a hard drive, Factory repair policy – Powerware Model V-2000B User Manual

Page 112

background image

110 = Maintenance

Replacing a Hard Drive

Generally, the only time that a hard drive should be removed from the disk array is when the drive

array diagnostic software identifies a permanent fault. In this case, the front panel DRIVES LED will
blink. Use the hard disk management tools to verify that a drive is at fault. The application

monitors many things about the array and individual drives, and will clearly indicate whether a

drive has failed.
Each hard drive bay is numbered 0 through 3, as are the drives. If for any reason one or more

drives have been removed, they must be reinstalled in a bay whose num ber matches the drive.

Installation in the wrong location will damage data stored on all drives.

1. Turn system power OFF with the front panel button. After it has shut down, turn off the AC

power switch and unplug the AC power cord.

2. Remove the front panel as described above.
3. Unscrew the holding plate from the front of the drive sub-chassis.
4. Disconnect the power and Serial ATA data cable from the drive, and remove it from the

drive bay.

5. Replace the drive, fasten the holding plate in place, and reattach drive cables. Note that

the data cables are numbered; re-attach then to the same drive location from which they

were removed.

6. Replace the front panel and tighten the two large screws.
7. Replace the AC power cord and turn on the rear panel AC switch.
8. Turn the system ON using the front panel button and check the RAID array status.
9. Check for correct operation of the server.

NOTE: All drives in the RAID array must be identical.

Factory Repair Policy

A video server being returned under warranty shall be sent to 360 Systems, freight prepaid, in the

original or equivalent packaging. Call 360 Systems for a return authorization number before

returning a product.
Use the following address for shipping and correspondence. 360 Systems’ offices are open

Monday through Friday, from 8:30 AM to 5:00 PM, Pacific Time.

360 Systems

Telephone (818) 991-0360

Customer Service Dept.

Fax

(818) 991-1360

31355 Agoura Road

E-mail

[email protected]

Westlake Village, CA 91361

Website

www.360systems.com