Polycom 6000 - Manual (Page 11)

Introducing the Polycom QDX 6000 Systems
1 - 3
Powering On and Off
Connect power and power on the system after you have connected all of the
equipment that you will use with it. Make sure that the system is powered off
before you connect devices to it.
Powering On the Polycom QDX 6000 Systems
To power on the Polycom QDX 6000 systems:
 Press the power switch on the back of the system.
The Polycom splash screen is displayed within about 1 minute.
To power off the Polycom QDX 6000 systems:
 Press the power switch on the back of the system.
The indicator light on the front of the Polycom QDX 6000 system provides this
information:
Indicator Light System Status
Off System is powered off.
Steady red light System is initializing.
Blinking red light System is updating software.
Steady green light System is in a call.
Blinking red light against steady green
light System received an IR signal while in
a call.
Steady blue light System is awake, not in a call.
Blinking red light against steady blue light System received an IR signal while
awake and not in a call.
Blinking blue light (on 1 sec, off 1sec) System is asleep.