Paradyne 3800PLUS User Manual
Page 77
Configure Branch
8-17
3980-A2-GB30-40
October 1998
Table 8-2
(4 of 5)
DTE Dialer Configuration Options
*ResultCode Form: Words
Nxt
Words
Numbers (1)
Numbers (2)
Result Codes Format. Controls whether or not result codes appear as words or as numeric codes. Some DTEs do not
recognize Result Codes as words; therefore, numbers are required. The Numbers (2) format is required for some
modem pooling applications. (For a list of Result Codes, refer to
The factory default is Words.
AT command equivalent is V
n.
V25bis Coding: ASCII
Nxt
ASCII
EBCDIC
V.25bis Coding. Identifies to the modem whether the DTE is using ASCII code or EBCDIC code for V.25bis commands.
The modem responds to the DTE using the same coding.
NOTE: This configuration option only appears if DTE Dialer is configured for V25bis HDLC or V25bis Bisync.
The factory default is ASCII.
AT command equivalent is S-register S62=
n.
V25bis IdleFill: Mark
Nxt
Mark
Flag
V.25bis Idle Fill. Determines whether a mark or flag is used as an idle fill character for the DTE. The modem responds to
the DTE using the same idle fill.
NOTE: This configuration option only appears if DTE Dialer is configured for V25bis HDLC.
The factory default is Mark.
AT command equivalent is S-register S63=
n.
V.25b NewLineChr: CR+LF
Nxt
CR+LF
CR LF
V.25bis New Line Character. Sets the modem for the command line terminator used by the DTE in V.25bis Async mode.
The modem responds to the DTE using the same line terminator.
NOTE: This configuration option only appears if DTE Dialer is configured for V25bis Async.
The factory default is CR+LF.
AT command equivalent is S-register S64=
n.
* This configuration option only appears if DTE Dialer Type is configured for AT.