beautypg.com

Paradyne 3800PLUS User Manual

Page 141

background image

AT Command Set and S-Registers

13-7

3980-A2-GB30-40

October 1998

Table 13-1

(5 of 15)

3800

Plus AT Commands

AT Command

Front Panel Branch

Description

X

n

Extended Result Code, Dial Tone Detect, and Busy Tone Detect
Configuration Options

Dial

Busy

Extended

Tone

Tone

Result Code Detect

Detect

X0

Disable

Disable

Disable

X1

Enable

Disable

Disable

X2

Enable

Enable Disable

X3

Enable

Disable

Enable

X4

Enable

Enable

Enable

X5

Add/EC

Enable

Enable

X6

Add/V42,MNP

Enable

Enable

X7

Use DTE Rate

Enable

Enable

Extended Result Code

Enable. Displays all result codes listed in Appendix B except for error

control suffix.

Disable. Only displays OK, CONNECT, RING, NO CARRIER, ERROR.

Add/EC. Displays result codes with /EC suffix. Add/V42,MNP. Displays

result codes with either V.42 or MNP suffix. Use DTE Rate.
Displays DTE data rate instead of line rate.

Add/V42,MNP. Displays result codes with either V.42 or MNP suffix.

Use DTE Rate. Displays DTE data rate instead of line rate.


Extended Result Code:
Configure\Edit\DTE Dialer

Dial Tone Detect:
Configure\Edit\
Line Dialer

Busy Tone Detect:
Configure\Edit\
Line Dialer

Dial Tone Detect

Enable. Sets the modem for dial tone detect.

Disable. Sets the modem for blind dialing.

Busy Tone Detect

Enable. Modem monitors for busy tone.

Disable. Modem ignores busy tone.

Y

n

Long Space Disconnect
Y0

Disable. Ignores long space.

Y1

Enable. Disconnects if long space is detected. Enables
transmission of a long space.

Configure\Edit\
Line Dialer

Z

n

Reset and Load Active
Z0

Loads configuration options from Active (Saved) to Active
(Operating).

Z1

Loads configuration options from Customer 1 to Active (Operating).

Z2

Loads configuration from Customer 2 to Active (Operating).

Z3

Loads configuration options from Active (Saved) to Active
(Operating) and performs a reset (if the modem is connected, it is
disconnected).

Z9

Performs a full modem reset, as if the power were turned off and
on.

Control\Reset