Call setup branch – Paradyne 3800PLUS User Manual

Page 42

COMSPHERE 3800Plus Modems

5-2

October 1998

3980-A2-GB30-40

Call Setup Branch

In the following descriptions, the shaded key indicates

what key to press to perform the described operation.

To access the Call Setup branch from the Top-Level

menu, select Call Setup:

Idle: 28.8

Call_Setup

Dial

Dial allows you to dial any telephone number stored in

directory locations 1–10. Any telephone number dialed
using the DCP must already exist in a directory location.
Refer to Change Directory for information on storing
telephone numbers in directory locations.

To access Dial from the Call Setup branch, make the

following selection:

Call Setup:

Dial Disconnect

Select Dial to display the first directory telephone

number.

Dial Directory:
Nxt 01:5551234

To view other directory locations, select Nxt.

Dial Directory: 01
Dialing

Once the directory location you want appears on the

LCD, press the F2 or F3 key to dial the number.

If the connection is successful, the modem is online

and one of the Normal Operation status messages appears
on the LCD. If the connection is not successful, the LCD
displays one of the Call Failure status messages. (See

Table 3-3

in Chapter 3.)

If DTE dialing is enabled and any character is received

from the DTE before the modem goes online, the dial
sequence is aborted. This is known as any-key abort.

AT Command Equivalent

The AT command equivalent for Dial is DS=n, where n

is directory location 1–10.

Disconnect

Disconnect allows the modem to go on-hook (hang

up). Use this function when you want to disconnect an
established call on a dial line.

To access Disconnect from the Call Setup branch,

make the following selection:

Call Setup:

Dial Disconnect