Paradyne 3800PLUS User Manual

Page 116

COMSPHERE 3800Plus Modems

10-2

October 1998

3980-A2-GB30-40

Remote DCP access is accomplished using either the

primary or secondary channel (if available) of the VF line.
Using the primary channel gives a much faster response
time due to the higher data rate, but it also interrupts data
flow because primary data is stopped when Remote mode
is active. Once Remote mode is terminated, the primary
channel is automatically made available to data
transmission.

Unlike primary channel communications, the

secondary channel operates at a slower data rate and does
not interrupt data flow. (V.34, V.32terbo, V.32bis, and
V.32 are the only modulations available on the secondary
channel.)

To access the Remote branch, make the following

selections:

Online : 28.8

Control Remote

Press the

key until Remote appears. Select

Remote.

NOTE

If a connection is not established
between a local 3800

Plus

modem and a remote 3800

Plus

modem, the LCD displays
Remote Mode Fail – No
Circuit. Press the key to
return to the Top Level menu,
and dial again.

Select Channel

Secondary

Select Channel

Prim (data blckd)

If operation over the secondary channel is desired,

press any function key to select the secondary channel.
Secondary channel only appears if using V.34,
V.32 terbo, V.32bis, or V.32 modulation. If operation
over the primary channel is desired, press the

key

until Prim appears, and press any function key.

Online : 28.8
Control ExitRem

If the remote modem accepts the password and the

entry is successful, the Top-Level menu of the remote
modem appears on the local modem’s LCD. An appears
in the upper right-hand corner indicating that what is
displayed on your LCD is actually the Top-Level menu of
the remote 3800Plus modem.