Common operational messages, Dial access security messages, To all menu tree branches from the dcp begins – Paradyne 3800PLUS User Manual
Page 36: Op-level menu, the head of the menu hierarchy, S top line identifies the modem status, as listed, Table 4-4, Table 4-5, Messages listed in, Are common operational, Messages that occur during modem operation. these
COMSPHERE 3800Plus Modems
4-10
October 1998
3980-A2-GB30-40
Table 4-4
Common Operational Messages
Common
Operational
Messages
Indicates
Please Wait...
Appears when a command to a local device takes more than two seconds to complete.
Command Sent...
Appears when a command is sent to a remote modem.
No Rem Response or
Remote Modem Fail
Appears when a remote modem does not respond to a command within 5 seconds.
Command Complete
Appears when a command, issued to a local or remote modem, is completed.
Invalid Command
Appears when the modem cannot complete a command.
Table 4-5
Dial Access Security Messages
Dial Access
Security
Messages
Indicates
Get VF PsWd
The answering modem is waiting for the originating caller to transmit a VF password.
Get DTE PsWd
The answering modem is waiting to receive a valid DTE password from the remote DTE.
VF PsWd Timeout
The modem did not finish answering a call (disconnected) because the allowed time limit was
exceeded before the modem received a VF password from the originating dialer.
Unknown DTEpswd
The modem did not finish answering a call (disconnected) because the DTE passwords received
from the remote DTE were invalid.
No Orig PsWd
The modem did not attempt to establish a call as requested because the AT dial command did not
contain an originate access password.
Unknown VF PsWd
The modem did not finish answering a call (disconnected) because the modem received an
invalid VF password.
DTEpswd Timeout
The modem did not finish answering a call (disconnected) because the allowed time limit was
exceeded before the modem received a DTE password from the remote DTE.
Inval Orig PsWd
The modem did not attempt to establish the call as requested because the originate password in
the AT dial command was not valid.
DTR Dial Blocked
Appears if DTR dialing is used and Answer Access or Originate Access security is enabled. DTR
dialing is not permitted when security is enabled.
SecurityBlocked
Appears only when the modem is in base mode (a mode that occurs during a firmware download)
and Answer Access Security is enabled. In this case, the access verification capabilities are not
available and the modem does not pass data to the DTE under any circumstances.