Paradyne 3800PLUS - Manual (Page 144)

COMSPHERE 3800Plus Modems
13-10 October 1998 3980-A2-GB30-40
Table 13-1
(8 of 15)
3800 Plus AT Commands
AT Command Front Panel Branch Description
& I Dial Transmit Level
When Dial Transmit Level Type is set to Permissive, & I n sets Dial Transmit
Level to a value between –10 and –32 dBm. & I 99 and & I 100 are available
only if Enhanced Throughput Cellular (ETC) is installed and cause the
level to be varied automatically according to conditions for ETC operation.
& I 10 –10 dBm
& I 11 –11 dBm
S S
S S
& I 32 –32 dBm
& I 99 Automatically adjusted according to the ETC1.0 specification . Use
only with remote modems set to & I 99, and limit the data rate to
4800 bps (S41=5). Set by &F6.
& I 100 Automatically adjusted according to the ETC1.1 specification.
NOTE: &J0 overrides this command; & I n overrides the &J0 command.
Configure\Edit\Dial Line
&J n Dial Transmit Level Type
&J0 Permissive (Approx. – 9 dBm).
NOTE: &J0 overrides the & I n command; & I n overrides the
&J0 command.
Configure\Edit\Dial Line
&L n Leased Mode
&L0 Disables leased-line operation.
&L1 2-wire originate leased-line operation.
&L2 4-wire originate leased-line operation.
&L3 2-wire answer leased-line operation.
&L4 4-wire answer leased-line operation.
The &L command will cause the modem to reset before entering or exiting
Leased-Line mode. Therefore, it must be entered as the last command in
an initialization string. The modem must be in Sync Leased mode (&F2 or
&F4) for the &L command to work.
Configure\Edit\
Leased Line