Paradyne 3800PLUS User Manual
Page 139
AT Command Set and S-Registers
13-5
3980-A2-GB30-40
October 1998
Table 13-1
(3 of 15)
3800
Plus AT Commands
AT Command
Front Panel Branch
Description
DS=
n
Dial Stored Number
Dials the number stored in Location
n (1–10). (To store a telephone
number, refer to the &Z
n=x command.)
If any character is received from the DTE before the modem goes online,
the dial sequence is aborted. This is known as any-key abort.
Call Setup\Dial\
Dial Directory:
E
n
Command Character Echo
E0
Disables echo to the DTE.
E1
Enables echo to the DTE.
Configure\Edit\
DTE Dialer
H
n
Hook Switch Control
H0
Modem goes on-hook.
H1
Modem goes off-hook.
H0: Call
Setup\Disconnect
or
Control\Remove Make
Busy
H1: Control\ Make Busy
I
n
Identification
I
0
Displays product code; default is 144.
I
1
Displays 3-digit firmware revision number.
I
2
Performs an EPROM check.
I
3
Displays the modem’s serial number.
I
4
Displays the modem’s model number. The model number of a
3810
Plus begins with 3980. The model number of a 3811Plus
begins with 3981.
I
5
Displays the part number of the circuit card.
I
6
Displays the firmware release number.
I
9
Displays 3-digit firmware revision number (same as
I
1).
I
10=
n Changes the value of the product code displayed by the
I
0 command;
n is a number from 0 to 4:
I
10=0 sets product code to 144
I
10=1 sets product code to 240
I
10=2 sets product code to 480
I
10=3 sets product code to 960
I
10=4 sets product code to 120
I
11
Performs a checksum of the modem’s firmware and displays the
results in hexadecimal. (There is no DCP equivalent of this
command.)
I
19
Displays the entire firmware revision level.
Status\Identity
L
n
Speaker Volume
L0
Selects low volume.
L1
Selects low volume.
L2
Selects medium volume
L3
Selects high volume.
Control\Speaker
Configure\Edit\Misc
M
n
Speaker On/Off
M0
Speaker always off.
M1
Speaker on until carrier signal is detected.
M2
Speaker always on.
Control\Speaker
Configure\Edit\Misc
O
Return to Online or Data Mode
Returns modem to Data mode from Online Command mode.
None