Paradyne 3800PLUS - Manual (Page 151)

AT Command Set and S-Registers
13-17 3980-A2-GB30-40 October 1998
Table 13-1
(15 of 15)
3800 Plus AT Commands
AT Command Front Panel Branch Description
#SC n Sync Comp Mode
Enables and disables synchronous data compression.
#SC0 Disable Synchronous Data Compression mode.
#SC1 Enable Synchronous Data Compression mode.
The factory setting is Disable.
Configure\Edit\
V42/MNP/Buffer
I H n V.42bis Compression
I H0 Disable.
I
H1 Transmit only. (Not available from DCP.)
I
H2 Receive only. (Not available from DCP.)
I H3 Transmit and Receive. (Equivalent to Enabled option on DCP.)
Configure\Edit\
V42/MNP/Buffer
I L n Disconnect at 300 bps
I
L0 Disable.
I L1 Enable.
None