Perle Systems Perle IOLAN DS1 - Manual (Page 82)

Serial Port Profiles
82 IOLAN DS1/TS2 User’s Guide, Version 3.4
Advanced Tab Field Descriptions
The TruePort Advanced tab determines how the TruePort connection is initiated and then sets up the
appropriate connection parameters.
Configure the following parameters:
Signals high
when... When a TruePort line becomes active, this option has the following impact:
z TruePort Lite Mode—When enabled, the EIA-232 signals remain high
(active) before, during, and after the TruePort session. When disabled, the
EIA-232 signals remain low (inactive).
z TruePort Full Mode—During the session, the TruePort client will be
control the state of these signal before and after the connection.
Default: Enabled
Enable Message of
the Day (MOTD) Enables/disables the display of the message of the day.
Default: Disabled
Idle Timeout Use this timer to close a connection because of inactivity. When the Idle
Timeout expires, the IOLAN will end the connection.
Default: 0 seconds so the port will never timeout
Range: 0-4294967 seconds (about 49 days)
Session Timeout Use this timer to forcibly close the session/connection when the Session
Timeout expires.
Default: 0 seconds so the port will never timeout
Range: 0-4294967 seconds (about 49 days)
Dial In If the device is remote and will be dialing in via modem or ISDN TA, enable
this parameter.
Default: Disabled
Dial Out If you want the modem to dial a number when the serial port is started, enable
this parameter.
Default: Disabled