Perle Systems Perle IOLAN DS1 - Manual (Page 196)

Introduction
196 IOLAN DS1/TS2 User’s Guide, Version 3.4
IOLAN RJ45
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
3. To turn line termination on , locate and jumper both J1 and J9.
4. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
IOLAN DB9
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
3. To turn line termination on , locate and jumper both J1 and J9.
4. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
Power
Dip
Switch
Reset
RJ45
RJ45 Ser
ial
Screw
Screw
J1 J9
Power
Dip
Switch
Reset
RJ45
DB9 Ser
ial
Screw
Screw
J1
J9