Panasonic WJ-NT204 - Manual (Page 58)

58
1. Press the DIAL button.
The DIRECT DIAL dialog appears.
2. Press the REDIAL button. The dialog screen displays
the IP address that has been the latest dialing.
3. Press the CALL button. The dialog screen changes to
“CONNECTING” and the unit starts dialing.
During communication, the CONNECT indicator will illu-
minate.
4. To terminate the call, hold down the DIAL button for 2
seconds. The dialog changes to “LINE TERMINATED”.
■ Sequential Dialing (Receiver )
The sequential dialing can be operated only at the Control
site to call the Remote sites one after another. The dialing
sequence traces the sites that are designated to SEQ. ON
in the 320 QCK# LIST. The sequence also follows the
assignments specified in the 330 SEQ.DIAL setup. It starts
with the start site, retains communication for the duration,
advances to the next site, and repeats the round if applied.
1. Press the QUICK button.
The QUICK dialog appears accompanied with the
directory.
DIRECT DIAL
IP ADDRESS:
192.168. 0. 11
ENTER IP ADDRESS,THEN PRESS CALL
KEY,DIALING.
←→
:MOVE CALL:CALL DEL:NO.CLEAR
ONE TOUCH DIAL:CALL
REDIAL:REDIAL NO. DIAL/ESC:CLEAR
DIRECT DIALING
IP ADDRESS:
192.168. 0. 11
DIAL/ESC:CANCEL
CONNECTING
LINE TERMINATED
ESC:CLEAR
QUICK DIAL
QUICK#:
N0.
IP ADDRESS:
. . .
DIRECTORY:
001 Trans.01
002 Trans.02
003 Trans.03
004 Trans.04
005 Trans.05
↑↓
←→
:MOVE CALL:CALL DEL:BS
ENT:SELECT DIAL/ESC:CLEAR
LINK/
10BASE-T
100
BASE-TX CONNECT ACT
LOW HIGH
RING.VOL
POWER
ON
OFF
ESC
MENU
AF NEAR FAR TELE WIDE
Remote Controller WV-CU20
1 2 3
4 5 6
7 8
0
9
1 2 3 4 5
#
STEP 1
DIAL
PRESET SET
QUICK
STEP 2 STEP 3
CALL
REDIAL
DELETE
ENTER
AUDIO MUTE
ALM ACK VIDEO SWITCH
ONE TOUCH DIAL
AUTO/MANU SITE
4
5
1
3
2-3
2-1
2-2
DIRECT DIAL
IP ADDRESS:
. . .
ENTER IP ADDRESS,THEN PRESS CALL
KEY,DIALING.
←→
:MOVE CALL:CALL DEL:NO.CLEAR
ONE TOUCH DIAL:CALL
REDIAL:REDIAL NO. DIAL/ESC:CLEAR