Panasonic WJ-NT204 - Manual (Page 112)

113
t LOGOUT
Logs out of the WJ-SX550 control operation.
y CAMERA SELECT (Bottom window panel)
To select a camera (CAMERA 1 to 128) connected to
the WJ-SX550B. Select a camera number, and then
click
[SET] to apply it. The image of the selected cam-
era is displayed on the monitor in the previously select-
ed input mode.
u PRESET SELECT (Bottom window panel)
To move the combination camera (option) connected to
the WJ-SX550B to any of 64 preset positions. Select a
preset position number, and then click the
[SET] button
to move the camera to the position.
i ALARM ALL RESET
To reset all alarms activated in the Matrix Switcher, and
return it to normal condition.
Note: Follow the resetting procedures for each alarm
mode setup in the WJ-SX550A/B.
• When MODE 1 is set, select the MONITOR 1,
then reset the alarm.
• When MODE 2 is set, select any of the MONI-
TOR 1 through 4, then reset the alarm.
• When MODE 3 is set, select the same MONI-
TOR that is set in the WJ-SX550A/B, then reset
the alarm.
o PAN/TILT
Click on any of the pan/tilt buttons: Up, Down, Right or
Left to move the pan/tilt head of the Combination cam-
era to the desired direction. Click the button repeatedly
as necessary not holding down it.
!0 ZOOM
Click the button to zoom in or out. Instead holding
down the button, click on it repeatedly as necessary.
TELE: Zooms in the image.
WIDE: Zooms out the image.
!1 FOCUS
Click NEAR or FAR to adjust the focus of the image
manually. Instead holding down the button, click on it
repeatedly as necessary.
NEAR: Manual focusing
FAR: Manual focusing
AUTO: The built-in focus mechanism performs in the
Combination camera.
!2 IRIS
The connected combination camera (option) can be
controlled to close or open iris by clicking the
[CLOSE]
or [OPEN] button under IRIS.
Clicking the [OPEN] or [CLOSE] button will open or
close the camera iris for a specified time, after which
the operation is released automatically.
Clicking the
[RESET] button on the screen will reset
the iris of the displayed camera to the factory default
setting. Iris control cannot be retained by keeping the
[OPEN] or [CLOSE] button depressed. You need to
click the [OPEN] or [CLOSE] button again.
!3 AUTO PAN
The auto pan status of the connected combination
camera (option) can be changed by clicking the
[ON] or [OFF] button under AUTOPAN.
Note: When LOCAL is selected in the camera setup
menu, auto pan is released automatically within 1
minute. When REMOTE is selected, auto pan will
not be released automatically.
!4 Status Display
Displays information when an alarm is activated on the
Matrix Switcher.
!5 Image Display
Displays the image output supplied from the Matrix
Switcher connected to the WJ-NT204. Set the monitor
outputs of the Matrix Switcher to match the video inputs
of the WJ-NT204.