Panasonic WJ-NT204 - Manual (Page 106)

107
EXTENSION FUNCTIONS
You may see dark stripes in the edges of image display. These are added by the devices connected to the transmitter for the
administration purposes
■ WJ-MP204 Data Multiplexer Control
● Connection
(1) Connect SPOT OUT on the rear of the WJ-MP204 to VIDEO IN AUX on the rear of the WJ-NT204.
(2) Connect the RS-485 ports of both units with an RS-485 cable.
● Setup
(1) On the ADMINISTRATOR SETUP PAGE, click the [SERIAL PORT] button to open the SERIAL PORT SETUP window. For
TYPE , select PS • Data. Set the same communication parameters as for the WJ-MP204.
(2) On the ADMINISTRATOR SETUP PAGE, click the [MODE SETUP] button to open the MODE SETUP window.
Make the CONTROL SETUP as follows.
CAMERA CONTROL: COAX
AUX SYSTEM: MP204
● Control Operation
On the Location bar, type http://192.168.0.10 to open the WJ-MP204 OPERATION VIEW window.
q
y
r
e
t
!2
u o !0 i !1
!3
LINK/ 10BASE-T 100 BASE-TX CONNECT ACT
LOW HIGH
RING.VOL
Network Interface Unit WJ-NT
POWER
ON OFF
PC
PC
PC
PC
WJ-MP204
WJ-NT204
#1 #4 #2 #3
AUX
2 3 4
VIDEO IN
PS.Data
LAN
1
Note: Set DIP switch #3 on the rear of WJ-NT204 to ON.