Panasonic WJ-NT204 - Manual (Page 12)

12
Bit # OFF ON Function/Note
Maintenance
HTML file
1 Normal Operation * Initialize(1)
2 Normal Operation * Initialize(2)
Not Used 3 *
Applicable Line 4 See below *
Applicable Line 5 See below *
Network
Configuration
6 Normal Operation* Initialize(3)
Not Used 7 *
Setup Menus 8
Setup Menu
Enabled *
Menu Disabled
Host Port
Selection
9 RS-485 Rear RS-232C Front*
Not Used 10 *
1 2 3 4 5 6 7 8 9 10
OFF
ON
Initialize(1) will reset all settings including IP address back
to the factory default.
Initialize(2) will reset the HTML contents files back to the
factory default settings.
Initialize(3) will reset the IP address, subnet mask and
default gateway back to the factory default settings.
Applicable Line
!0 Mode DIP Switch [MODE]
The default setting is marked with *.
After changing the DIP switch, make sure to turn OFF
the power switch once and then turn it ON, or press the
RESET button to take in the new settings to the unit.
OFF ON
OFF AUTO * 10BASE-T
ON 100BASE-TX AUTO
Bit #4
Bit #5